첨부파일 다운로드
-
Specification
P3026-24PoE-V2F4CM.pdf
- 확장자 :
- 파일크기 :
- 215KB
L2+ Managed POE+ switch
22*10/100/1000M RJ45 Ports + 2*TP/SFP Combo Ports + 2*Gigabit SFP Ports
Total Power: 400W
256 G Switching Capacity in Gigabits per Second (Gbps)
| P3026-24PoE-V2F4CM | |
| Performance (Switching capacity and forwarding rate) | |
| Buffer Memory | 38.69Mpps |
| Capacity in Millions of Packets per Second (mpps) (64-byte packets) | |
| Bandwidth | 256G |
| Switching Capacity in Gigabits per Second (Gbps) | |
| Interface | |
| Ports | 22*10/100/1000M RJ45 Ports + 2*TP/SFP Combo Ports + 2*Gigabit SFP Ports |
| Layer2 Switching | |
| Spanning Tree | Standard Spanning Tree 802.1d Rapid Spanning Tree (RSTP) 802.1w |
| Protocol (STP) | |
| G.8032 ERPS | <50ms ring protection for industrial high reliable application |
| Aggregation | Link Aggregation Control Protocol (LACP) IEEE 802.3ad; |
| Up to 13 groups ; Up to 16 ports per group | |
| VLAN | Support up to 4K VLANs simultaneously (out of 4096 VLAN IDs) ; Port-based VLAN; 802.1Q tag-based VLAN |
| IGMP v1/v2 snooping | IGMP limits bandwidth-intensive multicast traffic to only the requesters; supports 1024 multicast groups (source-specific multicasting is not supported) |
| Security | |
| Secure Shell (SSH) Protocol | SSH secures Telnet traffic in or out the switch, SSH v1 and v2 are supported |
| Secure Sockets | SSL encrypts the http traffic, allowing advance secure access to the browser-based management GUI in the switch |
| Layer(SSL), HTTPS | |
| Port Security | Locks MAC Addresses to ports, and limits the number of learned MAC addresses |
| DHCP Snooping | prevent unauthorized configuration and use of IP addresses, while providing support for IP Source Guard and ARP detection |
| IP Source Guard | Prevents datagram with spoofed addresses from being in the network |
| ARP Inspection | Prevent ARP spoofing attacks and ARP |
| Storm control | Prevents traffic on a LAN from being disrupted by a broadcast, multicast, or unicast storm on a port |
| ACLs | Support for up to 256 entries; Drop or rate limitation based on source and destination MAC, VLAN ID or IP address, protocol, port, differentiated services code point (DSCP) / IP precedence, TCP/ UDP source and destination ports, 802.1p priority, Ethernet type, Internet Control Message Protocol (ICMP) packets, IGMP packets, TCP flag |
| Quality of Service | |
| Hardware | Support 8 hardware queues |
| Priority Queue | |
| Scheduling | 8 COS queues per port support strict priority and weighted round-robin (WRR) |
| Classification | Port based; 802.1p(PCP) VLAN priority based; |
| Rate Limiting | Ingress policer;egress shaping and rate control;per VLAN,per port and flow based |
| Management(Web/ SSL, Telnet/ SSH, ping, Trivial File Transfer Protocol (TFTP), SNMP, Syslog) | |
| Web GUI inter- face | Built-in switch configuration utility for browser- based device configuration (HTTP/ HTTPs). Supports configuration, system dashboard, maintenance, and monitoring |
| Dual Image | Dual image provides independent primary and secondary OS files for backup while upgrading |
| Firmware upgrade | Web browser upgrade (HTTP/ HTTPs) and TFTP; Upgrade through console port as well |
| Port mirroring | Traffic on a port can be mirrored to another port for analysis with a network analyzer or RMON probe. Up to N-1 (N is Switch’s Ports) ports can be mirrored to single destination port. A single session is supported. |
| Other management | Single IP management; HTTP/HTTPs; SSH; RADIUS; DHCP Client; SNTP; cable diagnostics; ping; syslog; Telnet client (SSH secure support) |
| Green Ethernet | |
| Green and Energy-saving Ethernet (EEE) | Compliant IEEE802.3az Energy Efficient Ethernet Task Force. Automatically turns off power onGigabit Ethernet RJ-45 port when detecting link down or Idle of client. Active mode is resumed without loss of any packets when the switch detects the link up |
| General | |
| Jumbo frames | Frame sizes up to 9KB supported on Gigabit interfaces |
| MAC Table | Up to 8K MAC addresses. |
| Discovery | |
| Link Layer | Used by network devices for advertising their identities, capabilities, and neighbors on a IEEE 802 local area network, principally wired Ethernet. |
| Discovery Protocol (LLDP) | |
| PoE | |
| PoE Standard: | IEEE802.3af/at |
| PoE Ports: | 24 ports support PoE |
| Power | Max 30W per PoE port, can be customized by Web management software |
| Power Pin Type: | End-span (Mid-span optional) |
| Minimum Requirements | |
| Web brower | Mozilla Firefox version 2.5 or later, Microsoft Internet Explorer version 6 or later; |
| Cable | Category 5 Ethernet network cable; |
| Other | TCP/IP, network adapter, and network operating system (such as Microsoft Windows, Linux, or Mac OS X) installed on each computer in network |
| Environmental (preliminary) | |
| Dimensions | 440 * 290 * 44.5mm |
| Working Environment | Operating temperature: -20 to 55 ℃; Storage temperature: -20℃ to 75 ℃; |
| Operating humidity: 10% to 90% , relative, non- condensing | |
| Product Description | 26-Port gigabit managed PoE switch, 22*10/100/1000M RJ45 Ports + 2*TP/SFP Combo Ports + 2*Gigabit SFP Ports, port 1-24 supports PoE, IEEE 802.3af/at standard, Max PoE power for each port is 30W. Can be customized by Web management software. Total input power is 400W |
| Note: Default power supply pin type is end- span(1/2+, 3/6-), mid-span(4/5+, 7/8- ) is optional | |