첨부파일 다운로드
-
Specification
P3010-8POE-MHF2.pdf
- 확장자 :
- 파일크기 :
- 403KB
Product Features
· The P3010-8POE-MHF2 series is a L2+ managed PoE fiber switch. It has 8*10/100/1000Base-T RJ45 ports
and 2*100/1000Base-X SFP fiber slot ports . Port 1-8 can support IEEE 802.3af/at standard PoE power supply.
single port PoE power reaches 30W, and the maximum PoE output power is 130W(at-250W). As a PoE power
supply device, it can automatically detect and recognize the power receiving equipment that meets the standard
and supply power through the network cable.
Model | P3010-8POE-MHF2 | P3010-8POE-MHF2-at |
Interface Characteristics | ||
Fixed Port | 8*10/100/1000Base-T
PoE ports (Data/Power) 2*100/1000Base-X uplink SFP slot ports 1 * RS232 console port(115200,N,8,1) |
|
Ethernet Port | 10/100/1000Base-T(X),auto-sensing,Full/half
duplex MDI/MDI-X self-adaption |
|
Twisted Pair Transmission | 10BASE-T:
Cat3,4,5 UTP(≤100 meter) 100BASE-TX: Cat5 or later UTP(≤100 meter) 1000BASE-T: Cat5e or later UTP(≤100 meter) |
|
SFP Slot Port | Gigabit
SFP optical fiber interface, default matching optical modules (optional order single-mode / multi-mode, single fiber / dual fiber optical module. LC) |
|
Optical Cable | Multi
mode: 850nm 0 ~ 550M,single mode: 1310nm 0 ~ 40KM, 1550nm
0 ~ 120KM. |
|
Chip Parameter | ||
Network Management Type |
L2+ | |
Network Protocol | IEEE802.3
10BASE-T; IEEE802.3i 10Base-T; IEEE802.3u 100Base-TX; IEEE802.3ab 1000Base-T IEEE802.3z 1000Base-X IEEE802.3x |
|
Forwarding Mode | Store and Forward(Full Wire Speed) | |
Switching Capacity | 192Gbps (Non-blocking) | |
Forwarding Rate@64byte |
14.88Mpps | |
MAC | 8K | |
Buffer Memory | 6M | |
Jumbo Frame | 9.6K | |
LED Indicator | Power
: PWR (green), system : SYS ( green), network: Link (yellow), fiber port :L/A (green), POE: PoE (green) |
|
Reset Switch | Yes, One-button factory reset | |
PoE & Power | ||
PoE Port | Port 1 to 8 IEEE802.3af/at @ POE | |
PoE Management | Total
power limit of PoE power supply PoE output power allocation, off& af &at PoE output priority configuration PoE working status Delay start of power supply Scheduling of PoE operation and time |
|
Power Supply Pin | Defaul 1/2 (+), 3/6 (-) | |
Max Power Per Port | 30W; IEEE802.3af/at | |
Total PWR / Input Voltage | 130W (AC100-240V) | 250W (AC100-240V) |
Power Consumption | Standby<8W, Full Load<120W | Standby<10W, Full Load<240W |
Power Supply | Built-in
power supply, AC 100~240V 50-60Hz 2.3A |
Built-in
power supply, AC 100~240V 50-60Hz 4.1A |
Physical Parameter | ||
Operation TEMP / Humidity | -20~+55°C, 5%~90% RH Non condensing | |
Storage TEMP / Humidity | -40~+75°C, 5%~95% RH Non condensing | |
Dimension (L*W*H) | 270*181*44.5mm | |
Net /Gross Weight | <1.7kg / <2.2kg | |
Installation | Desktop, 19 inch 1U cabinet | |
Certification & Warranty | ||
Lightning protection / protection level | Lightning protection: 4KV 8/20us; Protection level: IP30 | |
Certification | CCC,CE
mark, commercial; CE/LVD EN60950;FCC Part 15 Class B;
RoHS |
|
Warranty | 3 years, lifelong maintenance. | |
Network Management Features | ||
Interface | IEEE802.3X
(Full-duplex) Port temperature protection setting Port green Ethernet Energy-saving setting Broadcast storm control based on port speed The speed limit of the message flow in the access port. The minimum particle size is 64Kbps. |
|
Layer 3 Features | L2+
network management ,IPV4/IPV6 management L3 soft routing forwarding, Static route, Default route @ 128 pcs, APR @ 1024 pcs |
|
VLAN | 4K
VLAN based on port, IEEE802.1q VLAN based on the protocol VLAN based on MAC Voice VLAN, QinQ configuration Port configuration of Access, Trunk, Hybrid |
|
Port Aggregation | LACP,
Static aggregation Max 5 aggregation groups and 8 ports per group. |
|
Spanning Tree | STP (IEEE802.1d),RSTP (IEEE802.1w),MSTP (IEEE802.1s) | |
Industrial Ring | G.8032 (ERPS),Recovery time less than 20ms | |
Network Protocol | 250 Ring at most, Max 254 devices per ring. | |
Multicast | MLD
Snooping v1/v2,Multicast VLAN IGMP Snooping v1/v2, Max 250 multicast groups, Fast log out |
|
Port Mirroring | Bidirectional data mirroring based on port | |
QoS | Flow-Flow-based
Rate Limiting Flow-based Packet Filtering 8*Output queues of each port 802.1p/DSCP priority mapping Diff-Serv QoS,Priority Mark/Remark Queue Scheduling Algorithm (SP, WRR, SP+WRR) based Rate Limiting |
|
ACL | Port-based
Issuing ACL,ACL based on port and VLAN L2 to L4 packet filtering, matching first 80 bytes message. Provide ACL based on MAC, Destination MAC address, IP Source, Destination IP, IP Protocol Type, TCP/UDP Port, TCP/UDP Port Range, and VLAN, etc. |
|
Security | IP-MAC-IP-MAC-VLAN-Port
binding ARP inspection,Anti-DoS attack AAA & RADIUS,MAC learning limit Mac black holes,IP source protection IEEE802.1X & MAC address authentication Broadcast storm control,Backup for host datum SSH 2.0,SSL,Port isolation,ARP message speed limit User hierarchical management and password protection VLAN-Port binding |
|
DHCP | DHCP Client,DHCP Snooping, DHCP Server,DHCP Relay | |
Management | One-key
recovery Cable Diagnose,LLDP Web Management (HTTPS) NTP,System work log,Ping Test CPU instant utilization status view Console/AUX Modem/Telnet/SSH2.0 CLI Download & Management on FTP, TFTP, Xmodem, SFTP,SNMP V1/V2C/V3 NMS - smart network management system platform(LLDP+SNMP) |
|
System | Category
5 Ethernet network cable Web browser: Mozilla Firefox 2.5 or higher, Google browser chrome V42 or higher, Microsoft Internet Explorer10 or later; TCP/IP, network adapter, and network operating system (such as Microsoft Windows, Linux, or Mac OS X) installed on each computer in a network |